Administrator Guide
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) For IGMP version 2, the Interval range is from 100 to 25599. Introduced on the S6000-
ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds Enter the number of seconds between queries sent out. The range is from 1 to 18000.
The default is 60 seconds.
Defaults 60 seconds
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Internet Group Management Protocol (IGMP) 615