Administrator Guide
To disable IGMP snooping, use the no ip igmp snooping enable command.
Defaults Disabled.
Command Modes
• CONFIGURATION
• INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information To enable IGMP snooping, enter this command. When you enable this command from CONFIGURATION mode,
IGMP snooping enables on all VLAN interfaces (except the default VLAN).
NOTE: Execute the no shutdown command on the VLAN interface for IGMP Snooping to function.
ip igmp snooping fast-leave
Enable IGMP snooping fast-leave for this VLAN.
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Internet Group Management Protocol (IGMP) 627