Administrator Guide

Usage Information
The output of the show interfaces command displays the congured rate interval, along with the collected
trac data.
When rate-interval is not congured in the global conguration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is congured only in the global conguration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is congured at the interface level and not in the global conguration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is congured in both global conguration mode as well as interface mode, then the rate-interval
value congured at interface level is applied as it takes precedence over the global value.
show cong
Display the interface conguration.
Syntax
show config
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Example
668 Interfaces