Administrator Guide
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series. Modied to display the LAG failover group status.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following describes the show interfaces port-channel command shown in the following example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s LAG fate-sharing
group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group (“Failover-group”).
Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned,
that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface, it is the line speed of the
interfaces in the port channel.
Members in this... Displays the interfaces belonging to this port channel.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing... Displays the time when the show interfaces counters were cleared.
Queueing strategy. States the packet queuing strategy. FIFO means rst in rst out.
packets input... Displays the number of packets and bytes into the interface.
Input 0 IP packets... Displays the number of packets with IP headers, VLAN tagged headers, and MPLS
headers. The number of packets may not add correctly because a VLAN tagged IP packet
counts as both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that interface. This
information is displayed over two lines.
Received 0... Displays the type and number of errors or other specic packets received. This
information is displayed over three lines.
Interfaces 717