Administrator Guide
Version Description
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of ARP entries that the Route Table Manager can hold for a
specic VRF. This command does not apply to the management VRFs.
arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP request.
Syntax
arp retries number
Parameters
number Enter the number of retries. The range is from 1 to 20. The default is 5.
Defaults 5
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage Information Retries are 20 seconds apart.
Related Commands
• show arp retries — display the congured number of ARP retries.
740 IPv4 Routing