Administrator Guide
Version Description
7.5.1.0 Introduced on the C-Series.
clear ip b stack-unit
Clear all FIB entries in the specied stack unit (use this command with caution, refer to Usage Information.)
Syntax
clear ip fib stack-unit unit-number vrf vrf-name
Parameters
unit-number Enter the number of the stack unit.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to clear all FIB entries
corresponding to that VRF.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes trac disruption.
Related Commands
• show ip b stack-unit — show FIB entries on a specied stack-unit.
clear ip route
Clear one or all routes in the routing table.
Syntax
clear ip route [vrf vrf-name] {* | ip-address mask}
744 IPv4 Routing