Administrator Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or copy run
start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks and these blocks cannot be
reallocated. The ipv4acl prole range is from 1 to 4.
When conguring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM proles are from 1 to 10, except for the ipv6acl prole which is from 0 to 10. The ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any conguration changes that have changed
the NVRAM content, use the reload conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan {default | vlanopenflow {0|1}}
Defaults Disabled.
Parameters
default Reset VLAN CAM ACL entries to default settings
vlanopenow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Control and Monitoring 91