Administrator Guide

Version Description
pre-6.2.1.1 Introduced on the E-Series.
Related Commands
• mac learning-limit — set the MAC address learning limits for a selected interface.
• show mac-address-table aging-time — display the MAC aging time.
mac-address-table disable-learning
Disable MAC address learning from LACP or LLDP BPDUs.
Syntax
mac-address-table disable-learning [lacp | lldp]
Parameters
lacp Enter lacp to disable MAC address learning from LACP BPDUs.
lldp Enter LLDP to disable MAC address learning from LLDP BPDUs.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3048–ON, S3100 series, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, Z9100–ON, and Z9500.
Usage Information
If you use the mac-address-table disable-learning command without specifying any option, the
system does not learn source MAC addresses from LACP or LLDP BPDUs.
mac-address-table static
Associate specic MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address {multicast vlan vlan-id output—range
interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
multicast Enter a vlan port to where L2 multicast MAC trac is forwarded.
Layer 2 919