Administrator Guide

Usage Information The following describes the show mac-address-table command shown in the following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually congured (Static), learned dynamically
(Dynamic), or associated with a specic port (Sticky).
Interface Displays the interface type and slot/port information. The following abbreviations describe
the interface types:
• Po = port channel
• Gi = gigabit Ethernet
• Te = ten-gigabit Ethernet
State Lists if the MAC address is in use (Active) or not in use (Inactive).
Example
Dell(conf)# do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po 128 Active
2 00:00:00:00:00:02 Dynamic (N) Po 10 Active
2 00:00:00:00:00:03 Dynamic Po 100 Active
2 00:00:00:00:00:04 Dynamic Po 10 Active
Usage Information The following describes the show mac-address-table count command shown in the following example.
Line Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic Address... Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-dened MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example (Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Related Commands
• show mac-address-table aging-time — display MAC aging time.
Layer 2 931