Reference Guide
Usage Information This command manually brings up a disabled downstream interface that is in UFD-disabled error state. After the
downstream interface is up, it is not disabled until there are changes in the upstream interfaces. This command
does not have eect on downstream interfaces that are already up or interfaces that are not part of the UFD
group.
Example
OS10# clear ufd-disable interface ethernet 1/1/2
OS10# clear ufd-disable uplink-state-group 1
Supported Releases 10.4.0E(R3) or later
downstream
Adds an interface or a range of interfaces as a downstream interface to the uplink-state group.
Syntax
downstream {interface-type | interface-range}
Parameters
• interface-type — Enter the interface type as Ethernet or port-channel.
• interface-range — Enter the range of interfaces.
Default None
Command Mode UPLINK-STATE-GROUP
Usage Information You cannot assign an interface that is already a member of an uplink-state group to another group. The no version
of this command removes the interface from the uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# downstream ethernet 1/1/1
Supported Releases 10.4.0E(R3) or later
enable
Enables tracking of an uplink-state group.
Syntax
enable
Parameters None
Default Disabled
Command Mode UPLINK-STATE-GROUP
Usage Information The no version of this command disables tracking of an uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# enable
Supported Releases 10.4.0E(R3) or later
name
Congures a descriptive name for the uplink-state group.
Syntax
name string
System management 479