Reference Guide
3 Reload the switch in EXEC mode.
reload
The switch reboots with the new port conguration and resets the system defaults, except for the switch-port prole and these congured
settings:
• Management interface 1/1/1 conguration
• Management IPv4/IPv6 static routes
• System hostname
• Unied Forwarding Table (UFT) mode
• ECMP maximum paths
You must manually recongure other settings on a switch after you apply a new port prole and reload the switch.
NOTE: After you change the switch-port prole, do not immediately back up and restore the startup le without entering write
memory and reloading the switch. Otherwise, the new prole does not take eect.
Congure port prole
OS10(config)# switch-port-profile 1/1 profile-6
OS10(config)# exit
OS10# write memory
OS10# reload
Verify port prole
OS10(config)# show switch-port-profile 1/1
| Node/Unit | Current | Next-boot | Default |
|-------------+-------------------+-------------------|
| 1/1 | profile-2 | profile-2 | profile-1 |
Supported Profiles:
profile-1
profile-2
profile-3
profile-4
profile-5
profile-6
S4148-ON series port proles
On the S4148-ON series, port proles determine the available front-panel Ethernet ports and supported breakout interfaces on uplink ports.
In the port prole illustration, blue boxes indicate the supported ports and breakout interfaces. Blank spaces indicate ports and speeds that
are not available.
• 10GE mode is an SFP+ 10GE port or a 4x10G breakout of a QSFP+ or QSFP28 port.
• 25GE is a 4x25G breakout of a QSFP28 port.
• 40GE mode is a QSFP+ port or a QSFP28 port that supports QSFP+ 40GE transceivers.
• 50GE is a 2x50G breakout of a QSFP28 port.
• 100GE mode is a QSFP28 port.
NOTE
: For S4148U-ON port proles with both unied and Ethernet ports, see S4148U-ON port proles. An S4148U-ON unied
port supports Fibre Channel and Ethernet modes.
For example, profile-1 enables 10G speed on forty-eight ports (1-24 and 31-54), and 4x10G breakouts on QSFP28 ports 25-26 and
29-30; QSFP+ ports 27 and 28 are deactivated.
profile-3 enables 10G speed on forty ports, and 4x10G breakouts on all QSFP28 and
QSFP+ ports. Similarly, profile-1 disables 40G speed on ports 25-30; profile-3 enables 40G on these ports. See switch-port-prole
for a detailed description.
82
Interfaces