Manualshelf

Setup Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
21222324252627282930
23 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
S5248F-Leaf1A
S5248F-Leaf1B
interface vlan1612
description vMotion
no shutdown
interface vlan1613
description vSAN
no shutdown
interface vlan1614
description VM_Network_A
no shutdown
interface vlan1615
description VM_Network_B
no shutdown
interface vlan3939
description Internal_Mgmt
no shutdown
ipv6 mld snooping querier
interface vlan1612
description vMotion
no shutdown
interface vlan1613
description vSAN
no shutdown
interface vlan1614
description VM_Network_A
no shutdown
interface vlan1615
description VM_Network_B
no shutdown
interface vlan3939
description Internal_Mgmt
no shutdown
ipv6 mld snooping querier
7.1.3 Configure interfaces
Configure the interfaces for the jump box or laptop computer connections to be used during VxRail
deployment. This example uses 10GbE interface 1/1/9:1 on each switch.
Note: See Appendix B to change the native speed of S5248F-ON port groups from 25GbE to 10GbE for jump
box or laptop computer connections.
While only one connection to the jump box is required, two may be used for redundancy. Add these interfaces
as access ports on VLAN 1611 (the External Management VLAN).
Note: In this example, the jump box also provides DNS and NTP services as covered in Section 5.4. If these
services are on other devices, ensure the corresponding switch interfaces are also in the External
Management VLAN.
Configure the interfaces for connections to the VxRail nodes. Interfaces 1/1/17 through 1/1/20 are used in this
example.
Use the switchport mode trunk command to enable ports to carry traffic for multiple VLANs. Configure
the ports as access (untagged) ports on VLAN 1611 (the External Management VLAN). Configure the ports
as trunk (tagged) ports on VLANs 1612-1615, and 3939 (the vMotion, vSAN, VM Network, and Internal
Management VLANs).
Configure ports directly connected to nodes, servers, or other endpoints as STP edge ports. Set flow control
to “receive on” and “transmit off” on node-connected ports as a best practice.