Setup Guide

38 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
Note: For the dual switch without VLT topology, the VLAN portion of the command output is as follows:
NUM Status Description Q Ports
1 Active A Eth1/1/1-1/1/8,1/1/10:1,
1/1/11:1,1/1/12:1,1/1/13-1/1/16,1/1/21-1/1/52
A Po127
1611 Active External_Mgmt T Po127
A Eth1/1/9:1,1/1/17-1/1/20
1612 Active vMotion T Eth1/1/17-1/1/20
T Po127
1613 Active vSAN T Eth1/1/17-1/1/20
T Po127
1614 Active VM_Network_A T Eth1/1/17-1/1/20
T Po127
1615 Active VM_Network_B T Eth1/1/17-1/1/20
T Po127
3939 Active Internal_Mgmt T Eth1/1/17-1/1/20
T Po127
For the single switch topology, the VLAN portion is as follows:
NUM Status Description Q Ports
1 Inactive A Eth1/1/1-1/1/8,1/1/11:1,
1/1/12:1,1/1/13-1/1/16,1/1/25-1/1/56
1611 Active External_Mgmt A Eth1/1/9:1,1/1/10:1,
1/1/17-1/1/24
1612 Active vMotion T Eth1/1/17-1/1/24
1613 Active vSAN T Eth1/1/17-1/1/24
1614 Active VM_Network_A T Eth1/1/17-1/1/24
1615 Active VM_Network_B T Eth1/1/17-1/1/24
3939 Active Internal_Mgmt T Eth1/1/17-1/1/24
8.1.4 show ipv6 mld snooping interface
The show ipv6 mld snooping interface vlan 3939 command is used to verify MLD snooping and
querier are enabled on VLAN 3939 (shown in bold in the output below). These settings are required for
discovery of the VxRail nodes before creating the VxRail cluster.
S5248F-Leaf1A# show ipv6 mld snooping interface vlan 3939
Vlan3939 is up, line protocol is up
MLD version is 2
MLD snooping is enabled on interface
MLD snooping query interval is 60 seconds
MLD snooping querier timeout is 130 seconds
MLD snooping last member query response interval is 1000 ms
MLD snooping max response time is 10 seconds
MLD snooping fast-leave is disabled on this interface
MLD snooping querier is enabled on this interface
Multicast snooping flood-restrict is enabled on this interface