Users Guide

spanning-tree pvst vlan cost.
The range is from 0 to 200000.
Refer to the table for the default values.
• Change the port priority of an interface.
INTERFACE mode
spanning-tree pvst vlan priority.
The range is from 0 to 240, in increments of 16.
The default is 128.
The values for interface PVST+ parameters are given in the output of the show spanning-tree pvst command, as previously shown.
Conguring an EdgePort
The EdgePort feature enables interfaces to begin forwarding trac approximately 30 seconds sooner.
In this mode an interface forwards frames by default until it receives a BPDU that indicates that it should behave otherwise; it does not go
through the Learning and Listening states. The bpduguard shutdown-on-violation option causes the interface hardware to be
shut down when it receives a BPDU. When you only implement bpduguard, although the interface is placed in an Error Disabled state
when receiving the BPDU, the physical interface remains up and spanning-tree drops packets in the hardware after a BPDU violation.
BPDUs are dropped in the software after receiving the BPDU violation.
This feature is the same as PortFast mode in spanning tree.
CAUTION
: Congure EdgePort only on links connecting to an end station. EdgePort can cause loops if you enable it on an
interface connected to a network.
To enable EdgePort on an interface, use the following command.
• Enable EdgePort on an interface.
INTERFACE mode
spanning-tree pvst edge-port [bpduguard | shutdown-on-violation]
The EdgePort status of each interface is given in the output of the show spanning-tree pvst command, as previously shown.
Dell Networking OS Behavior: Regarding the bpduguard shutdown-on-violation command behavior:
• If the interface to be shut down is a port channel, all the member ports are disabled in the hardware.
• When you add a physical port to a port channel already in an Error Disable state, the new member port is also disabled in the hardware.
• When you remove a physical port from a port channel in an Error Disable state, the Error Disabled state is cleared on this physical port
(the physical port is enabled in the hardware).
• You can clear the Error Disabled state with any of the following methods:
• Perform a shutdown command on the interface.
• Disable the shutdown-on-violation command on the interface (the no spanning-tree stp-id portfast
[bpduguard | [shutdown-on-violation]]
command).
• Disable spanning tree on the interface (the no spanning-tree command in INTERFACE mode).
• Disabling global spanning tree (the no spanning-tree command in CONFIGURATION mode).
PVST+ in Multi-Vendor Networks
Some non-Dell Networking systems which have hybrid ports participating in PVST+ transmit two kinds of BPDUs: an 802.1D BPDU and an
untagged PVST+ BPDU.
Dell Networking systems do not expect PVST+ BPDU (tagged or untagged) on an untagged port. If this situation occurs, Dell Networking
OS places the port in an Error-Disable state. This behavior might result in the network not converging. To prevent Dell Networking OS from
Per-VLAN Spanning Tree Plus (PVST+)
583