Users Guide

To add routes from other routing instances or protocols, use the following commands.
Include directly connected or user-congured (static) routes in RIP.
ROUTER RIP mode
redistribute {connected | static} [metric metric-value] [route-map map-name]
metric-value: the range is from 0 to 16.
map-name: the name of a congured route map.
Include IS-IS routes in RIP.
ROUTER RIP mode
redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value] [route-map map-name]
metric-value: the range is from 0 to 16.
map-name: the name of a congured route map.
Include specic OSPF routes in RIP.
ROUTER RIP mode
redistribute ospf process-id [match external {1 | 2} | match internal] [metric value] [route-
map map-name]
Congure the following parameters:
process-id: the range is from 1 to 65535.
metric: the range is from 0 to 16.
map-name: the name of a congured route map.
To view the current RIP conguration, use the show running-config command in EXEC mode or the show config command in
ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in Dell Networking OS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other version,
use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP trac on the interfaces
participating in RIP unless the interface was specically congured for a specic RIP version.
Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
Examples of the RIP Process
To see whether the version command is congured, use the show config command in ROUTER RIP mode.
Routing Information Protocol (RIP)
625