Users Guide

snmp-server user name group-name 3 noauth auth md5 auth-password
• Congure an SNMP group (password privileges only).
CONFIGURATION mode
snmp-server group groupname {oid-tree} auth read name write name
• Congure an SNMPv3 view.
CONFIGURATION mode
snmp-server view view-name 3 noauth {included | excluded}
NOTE: To give a user read and write privileges, repeat this step for each privilege type.
• Congure an SNMP group (with password or privacy privileges).
CONFIGURATION mode
snmp-server group group-name {oid-tree} priv read name write name
• Congure the user with a secure authorization password and privacy password.
CONFIGURATION mode
snmp-server user name group-name {oid-tree} auth md5 auth-password priv des56 priv password
• Congure an SNMPv3 view.
CONFIGURATION mode
snmp-server view view-name oid-tree {included | excluded}
Select a User-based Security Type
Dell(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 ?
auth Use the SNMPv3 authNoPriv Security Level
noauth Use the SNMPv3 noAuthNoPriv Security Level
priv Use the SNMPv3 authPriv Security Level
Dell(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 noauth ?
WORD SNMPv3 user name
Reading Managed Object Values
You may only retrieve (read) managed object values if your management station is a member of the same community as the SNMP agent.
Dell Networking supports RFC 4001, Textual Conventions for Internet Work Addresses that denes values representing a type of internet
address. These values display for ipAddressTable objects using the snmpwalk command.
There are several UNIX SNMP commands that read data.
• Read the value of a single managed object.
snmpget -v version -c community agent-ip {identifier.instance | descriptor.instance}
• Read the value of the managed object directly below the specied object.
snmpgetnext -v version -c community agent-ip {identifier.instance | descriptor.instance}
• Read the value of many objects at once.
snmpwalk -v version -c community agent-ip {identifier.instance | descriptor.instance}
Examples of Reading the Value of Managed Objects
In the following example, the value “4” displays in the OID before the IP address for IPv4. For an IPv6 IP address, a value of “16” displays.
> snmpget -v 2c -c mycommunity 10.11.131.161 sysUpTime.0
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (32852616) 3 days, 19:15:26.16
> snmpget -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1.3.0
The following example shows reading the value of the next managed object.
> snmpgetnext -v 2c -c mycommunity 10.11.131.161 .1.3.6.1.2.1.1.3.0
SNMPv2-MIB::sysContact.0 = STRING:
> snmpgetnext -v 2c -c mycommunity 10.11.131.161 sysContact.0
Simple Network Management Protocol (SNMP)
715