Users Guide

The default is None.
• (From a management station) Identify the physical location of the system (for example, San Jose, 350 Holger Way, 1st oor lab, rack
A1-1).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysLocation.0 s “location-info”
You may use up to 55 characters.
The default is None.
Subscribing to Managed Object Value Updates using
SNMP
By default, the Dell Networking system displays some unsolicited SNMP messages (traps) upon certain events and conditions.
You can also congure the system to send the traps to a management station. Traps cannot be saved on the system.
Dell Networking OS supports the following three sets of traps:
• RFC 1157-dened traps — coldStart, warmStart, linkDown, linkUp, authenticationFailure, and egpNeighbborLoss.
• Dell Networking enterpriseSpecic environment traps — fan, supply, and temperature.
• Dell Networking enterpriseSpecic protocol traps — bgp, ecfm, stp, and xstp.
To congure the system to send SNMP notications, use the following commands.
1 Congure the Dell Networking system to send notications to an SNMP server.
CONFIGURATION mode
snmp-server host ip-address [traps | informs] [version 1 | 2c |3] [community-string]
To send trap messages, enter the keyword traps.
To send informational messages, enter the keyword informs.
To send the SNMP version to use for notication messages, enter the keyword version.
To identify the SNMPv1 community string, enter the name of the community-string.
2 Specify which traps the Dell Networking system sends to the trap receiver.
CONFIGURATION mode
snmp-server enable traps
Enable all Dell Networking enterprise-specic and RFC-dened traps using the snmp-server enable traps command from
CONFIGURATION mode.
Enable all of the RFC-dened traps using the snmp-server enable traps snmp command from CONFIGURATION mode.
3 Specify the interfaces out of which Dell Networking OS sends SNMP traps.
CONFIGURATION mode
snmp-server trap-source
Example of RFC-Dened SNMP Traps and Related Enable Commands
The following example lists the RFC-dened SNMP traps and the command used to enable each. The coldStart and warmStart traps are
enabled using a single command.
snmp authentication SNMP_AUTH_FAIL:SNMP Authentication failed.Request with invalid community
string.
snmp coldstart SNMP_COLD_START: Agent Initialized - SNMP COLD_START.
Simple Network Management Protocol (SNMP)
717