Users Guide
NOTE: The command line help still displays relevant details corresponding to each of these commands. However, these interface
range or interface group commands are not supported when Management VRF is congured.
Conguring a Static Route
• Congure a static route that points to a management interface.
CONFIGURATION
management route ip-address mask managementethernet ormanagement route ipv6-address prefix-
length managementethernet
You can also have the management route to point to a front-end port in case of the management VRF. For example: management
route 2::/64 gigabitethernet 1/1 .
• Congure a static entry in the IPv6 neighbor discovery.
CONFIGURATION
ipv6 neighbor vrf management 1::1 gigabitethernet 1/1 xx:xx:xx:xx:xx:xx
Sample VRF Conguration
The following conguration illustrates a typical VRF set-up.
Figure 130. Setup OSPF and Static Routes
874
Virtual Routing and Forwarding (VRF)