Administrator Guide

CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
The default is permit.
The optional seq keyword allows you to assign a sequence number to the route map instance.
The default action is permit and the default sequence number starts at 10. When you use the keyword deny in configuring a route map,
routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in ROUTE-MAP mode.
DellEMC(config-route-map)#show config
!
route-map dilling permit 10
DellEMC(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order.
Dell EMC Networking OS processes the route maps with the lowest sequence number first. When a configured route map is applied to a
command, such as redistribute, traffic passes through all instances of that route map until a match is found. The following is an
example with two instances of a route map.
The following example shows matching instances of a route-map.
DellEMC#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 1/1
Set clauses:
tag 35
level stub-area
DellEMC#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence
number to the command syntax.
DellEMC(conf)#no route-map zakho 10
DellEMC(conf)#end
DellEMC#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 1/1
Set clauses:
tag 35
level stub-area
DellEMC#
The following example shows a route map with multiple instances. The show config command displays only the configuration of the
current route map instance. To view all instances of a specific route map, use the show route-map command.
DellEMC#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Set clauses:
tag 3444
DellEMC#
To delete a route map, use the no route-map map-name command in CONFIGURATION mode.
Configure Route Map Filters
Within ROUTE-MAP mode, there are match and set commands.
• match commands search for a certain criterion in the routes.
102
Access Control Lists (ACLs)