Administrator Guide

If you do not use the all keyword, the next hop of only eBGP-learned routes is updated by the route reflector. If you use the all
keyword, the next hop of both eBGP- and iBGP-learned routes are updated by the route reflector.
• Sets the next hop address.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
If the set next-hop command is applied on the out-bound interface using a route map, it takes precedence over the neighbor
next-hop-self command.
Changing the WEIGHT Attribute
To change how the WEIGHT attribute is used, enter the first command. You can also use route maps to change this and other BGP
attributes. For example, you can include the second command in a route map to specify the next hop address.
• Assign a weight to the neighbor connection.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6-address | peer-group-name} weight weight
weight: the range is from 0 to 65535. The default is 0.
• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
weight: the range is from 0 to 65535.
NOTE: The weight assigned using the set weight command under route map configuration override the weight
assigned using the neighbor weight command.
DellEMC# configure terminal
DellEMC(conf)# router bgp 400
DellEMC(conf-router_bgp)# neighbor 10.10.10.1 remote-as 500
DellEMC(conf-router_bgp)# neighbor 10.10.10.1 weight 150
DellEMC(conf-router_bgp)# exit
In the above configuration example, the weight attribute for routes received from the neighbor 10.10.10.1 is set to 150.
To view BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode or the show running-
config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 64 parallel paths to a destination.
You can configure the maximum number of parallel routes (multipath support) to a destination in BGP.
NOTE: Dell EMC Networking recommends
not using multipath and add path simultaneously in a route reflector.
To allow more than one path, use the following command.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
Configure the following parameters:
• ebgp: Enable multipath support for external BGP routes.
• ibgp: Enable multipath support for internal BGP routes.
• number: Maximum number of parallel paths. The range is from 2 to 64.
DellEMC# configure terminal
DellEMC(conf)# router bgp 400
DellEMC(conf-router_bgp)# maximum-paths ibgp 5
DellEMC(conf-router_bgp)# exit
In the above example configuration, the maximum number of parallel internal BGP routes is set to 5, so that only 5 routes can be installed
in a routing table.
The show ip bgp network command includes multipath information for that network.
Border Gateway Protocol (BGP)
199