Administrator Guide

Old CAM
Threshold
New CAM Threshold Current CAM
Usage
Syslog
ACL_AGENT_CAM_USAGE_BELOW_THE_THRESHOLD: The
cam-usage of Ipv4Acl cam region on stack-
unit 0 Portpipe 0 Pipeline 0 is below 95%.
98 100 100 No syslog
95 80 10 No syslog
92 90 89 No syslog
CAM Optimization
When you enable the CAM optimization, if a Policy Map containing classification rules (ACL and/or DSCP/ ip-precedence rules) is applied
to more than one physical interface on the same port-pipe, only a single copy of the policy is written (only one FP entry is used). When
you disable this command, the system behaves as described in this chapter.
Troubleshoot CAM Profiling
The following section describes CAM profiling troubleshooting.
QoS CAM Region Limitation
To store QoS service policies, the default CAM profile allocates a partition within the IPv4Flow region.
If the QoS CAM space is exceeded, a message similar to the following displays.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (Gi 1/20) entries on portpipe 1 for stackunit 1
%EX2YD:12 %DIFFSERV-2-
DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for class 5
(Gi 1/22) entries on portpipe 1 for stackunit 1
If you exceed the QoS CAM space, follow these steps.
1. Verify that you have configured a CAM profile that allocates 24 K entries to the IPv4 system flow region.
2. Allocate more entries in the IPv4Flow region to QoS.
Dell EMC Networking OS supports the ability to view the actual CAM usage before applying a service-policy. The test cam-usage
service-policy command provides this test framework. For more information, refer to Pre-Calculating Available QoS CAM Space.
Content Addressable Memory (CAM)
221