Administrator Guide

INTERFACE mode
Dell(conf)# interface gigabitethernet 1/1
Dell(conf-if-gi-1/1)# eee
2. To disable EEE, use the no eee command.
INTERFACE mode
Dell(conf)# interface gigabitethernet 1/1
Dell(conf-if-gi-1/1)# no eee
View EEE Information
To view the details of Energy Efficient Ethernet (EEE), you can use the following show commands.
You have several options for viewing the details of EEE on interfaces.
• List all the interfaces.
EXEC mode
EXEC PRIVILEGE mode
show interfaces
This command displays the status of each interface with various details along with the information whether EEE is enabled on the
interfaces..
• List the status of eee on all the interfaces, on a specified port, or on a range of ports.
EXEC mode
EXEC PRIVILEGE mode
show interfaces eee
show interfaces interface-type slot/port eee
show interfaces interface-type slot/port-range eee
• List the statistical information of eee on all the interfaces, on a specified port, or on a range of ports.
EXEC mode
EXEC PRIVILEGE mode
show interfaces eee statistics
show interfaces interface-type slot/port eee statistics
show interfaces interface-type slot/port-range eee statistics
• List the hardware counters on a specified interface or a specified stack unit.
EXEC mode
EXEC PRIVILEGE mode
show hardware counters interface-type slot/port
show hardware stack-unit stack-unit-number unit unit-number counters
The following example shows the status information for all the interfaces.
S3048–ON
Dell# show interfaces
GigabitEthernet 2/1 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7
Current address is 00:01:e8:8b:3d:e7
Pluggable media present, Media type is unknown
Wavelength unknown
Interface index is 100992002
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Energy Efficient Ethernet : Yes
Last clearing of "show interface" counters 3d17h53m
Queueing strategy: fifo
Input Statistics:
Interfaces
303