Administrator Guide

CLI Command Mode Prompt Access Command
OPENFLOW INSTANCE
DellEMC(conf-of-instance-of-
id)#
openflow of-instance
PORT-CHANNEL FAILOVER-GROUP
DellEMC(conf-po-failover-grp)# port-channel failover-group
PRIORITY GROUP
DellEMC(conf-pg)# priority-group
PROTOCOL GVRP
DellEMC(config-gvrp)# protocol gvrp
QOS POLICY
DellEMC(conf-qos-policy-out-
ets)#
qos-policy-output
SUPPORTASSIST
DellEMC(support-assist)# support-assist
VLT DOMAIN
DellEMC(conf-vlt-domain)# vlt domain
VRRP
DellEMC(conf-if-interface-type-
slot/port-vrid-vrrp-group-id)#
vrrp-group
UPLINK STATE GROUP
DellEMC(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
DellEMC(conf)#protocol spanning-tree 0
DellEMC(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE, SPANNING TREE, and so
on.) without having to return to EXEC mode by preceding the EXEC mode command with the do command.
The following example shows the output of the do command.
DellEMC(conf)#do show system brief
Stack MAC : 34:17:eb:f2:c2:c4
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------
1 Management online S3048-ON S3048-ON 1-0(0-3932) 52
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
-------------------------------------------------------------
1 1 up AC absent 0
1 2 absent absent 0
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
------------------------------------------------------------------
1 1 up up 0 up 0
1 2 up up 0 up 0
1 3 up up 0 up 0
Speed in RPM
Configuration Fundamentals
35