Administrator Guide

This setting causes the multicast MAC address to be mapped to the Cluster IP address for the NLB mode of operation of the switch.
NOTE: While configuring static ARP for the Cluster IP, provide any one of the interfaces that is used in the static
multicast MAC configuration, where the Cluster host is connected. As the switch does not accept only one ARP-
interface pair, if you configure static ARP with each egress interface, the switch overwrites the previous egress-
interface configuration.
2. Associate specific MAC or hardware addresses to VLANs.
CONFIGURATION mode
mac-address-table static multicast-mac-address vlan vlan-id output-range interface
NOTE: When you use the mac-address-table static multicast-mac-address command in a VLT setup, Dell
EMC Networking OS recommends to add VLTi as one of the egress interfaces along with other cluster facing
interfaces.
Microsoft Network Load Balancing 443