Administrator Guide

To enable or disable fast-convergence, use the following command.
• Enable OSPF fast-convergence and specify the convergence level.
CONFIG-ROUTEROSPF- id mode
fast-convergence {number}
The parameter range is from 1 to 4.
The higher the number, the faster the convergence.
When disabled, the parameter is set at 0.
NOTE: A higher convergence level can result in occasional loss of OSPF adjacency. Generally, convergence level 1
meets most convergence requirements. Only select higher convergence levels following consultation with Dell
Technical Support.
In the following examples, Convergence Level shows the fast-converge parameter setting and Min LSA origination shows the
LSA parameters (shown in bold).
DellEMC(conf-router_ospf-1)#fast-converge 2
DellEMC(conf-router_ospf-1)#ex
DellEMC(conf)#ex
DellEMC#show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 2
Min LSA origination 0 secs, Min LSA arrival 0 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
DellEMC#
The following examples shows how to disable fast-convergence.
DellEMC#(conf-router_ospf-1)#no fast-converge
DellEMC#(conf-router_ospf-1)#ex
DellEMC#(conf)#ex
DellEMC##show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 5 secs, Min LSA arrival 1 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
DellEMC#
Changing OSPFv2 Parameters on Interfaces
In Dell EMC Networking OS, you can modify the OSPF settings on the interfaces.
Some interface parameter values must be consistent across all interfaces to avoid routing errors. For example, set the same time interval
for the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors.
To change OSPFv2 parameters on the interfaces, use any or all of the following commands.
• Change the cost associated with OSPF traffic on the interface.
CONFIG-INTERFACE mode
ip ospf cost
• cost: The range is from 1 to 65535 (the default depends on the interface speed).
• Change the time interval the router waits before declaring a neighbor dead.
CONFIG-INTERFACE mode
ip ospf dead-interval seconds
• seconds: the range is from 1 to 65535 (the default is 40 seconds).
The dead interval must be four times the hello interval.
The dead interval must be the same on all routers in the OSPF network.
• Change the time interval between hello-packet transmission.
CONFIG-INTERFACE mode
Open Shortest Path First (OSPFv2 and OSPFv3)
523