Administrator Guide

Traffic Monitor 0: normal 300 (50) peak 800 (50)
Out of profile yellow 23386960 red 320605113
Traffic Monitor 1: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 2: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 3: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 4: normal NA peak NA
Out of profile yellow 0 red 0
Configuring Port-Based Rate Shaping
Rate shaping buffers, rather than drops, traffic exceeding the specified rate until the buffer is exhausted. If any stream exceeds the
configured bandwidth on a continuous basis, it can consume all of the buffer space that is allocated to the port.
Dell EMC Networking OS Behavior: Rate shaping is effectively rate limiting because of its smaller buffer size. Rate shaping on tagged
ports is slightly greater than the configured rate and rate shaping on untagged ports is slightly less than configured rate.
Rate shaping buffers, rather than drops, traffic exceeding the specified rate until the buffer is exhausted. If any stream exceeds the
configured bandwidth on a continuous basis, it can consume all of the buffer space that is allocated to the port.
• Apply rate shaping to outgoing traffic on a port.
INTERFACE mode
rate shape
• Apply rate shaping to a queue.
QoS Policy mode
rate-shape
DellEMC#configure terminal
DellEMC(conf)#interface gigabitethernet 1/1
DellEMC(conf-if-gi-1/1)#rate shape 500 50
DellEMC(conf-if-gi-1/1)#end
Quality of Service (QoS)
603