Administrator Guide

[May 17 15:55:22]: CMD-(CLI):[show running-config]by default from console

[May 17 15:55:27]: CMD-(CLI):[show command-history]by default from console

DellEMC# show logging

Syslog logging: enabled

Console logging: disabled

Monitor logging: level debugging

Buffer logging: level debugging, 3 Messages Logged, Size (40960 bytes)

Trap logging: level informational

Last logging buffer cleared: May 17 15:52:54

%STKUNIT1-M:CP %SYS-5-CONFIG_I: Configured from console

%STKUNIT1-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by

default - repeated 3 times

%STKUNIT1-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by

default

File Transfer Services

With Dell EMC Networking OS, you can configure the system to transfer files over the network using the file transfer protocol (FTP).

One FTP application is copying the system image files over an interface on to the system; however, FTP is not supported on virtual local

area network (VLAN) interfaces.

If you want the FTP or TFTP server to use a VRF table that is attached to an interface, you must configure the FTP or TFTP server to use

a specific routing table. You can use the ip ftp vrf vrf-name or ip tftp vrf vrf-name command to inform the FTP or TFTP

server to use a specific routing table. After you configure this setting, the VRF table is used to look up the destination address. However,

these changes are backward-compatible and do not affect existing behavior; meaning, you can still use the source-interface

command to communicate with a particular interface even if no VRF is configured on that interface.

For more information about FTP, refer to RFC 959, File Transfer Protocol.

NOTE: To transmit large files, Dell EMC Networking recommends configuring the switch as an FTP server.

Configuration Task List for File Transfer Services

The configuration tasks for file transfer services are:

• Enable FTP Server (mandatory)

• Configure FTP Server Parameters (optional)

• Configure FTP Client Parameters (optional)

Enabling the FTP Server

To enable the system as an FTP server, use the following command.

To view FTP configuration, use the show running-config ftp command in EXEC privilege mode.

• Enable FTP on the system.

CONFIGURATION mode

ftp-server enable

DellEMC#show running ftp

ftp-server enable

ftp-server username nairobi password 0 zanzibar

DellEMC#

Configuring FTP Server Parameters

After you enable the FTP server on the system, you can configure different parameters.

To specify the system logging settings, use the following commands.

• Specify the directory for users using FTP to reach the system.

Management