Administrator Guide

peer-link port-channel id-number
5. Configure the IP address of the management interface on the remote VLT peer to be used as the endpoint of the VLT backup link for
sending out-of-band hello messages.
VLT DOMAIN CONFIGURATION mode
back-up destination ip-address [interval seconds]
You can optionally specify the time interval used to send hello messages. The range is from 1 to 5 seconds.
6. When you create a VLT domain on a switch, Dell EMC Networking OS automatically creates a VLT-system MAC address used for
internal system operations. To explicitly configure the default MAC address for the domain by entering a new MAC address, use the
following command.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
The format is aaaa.bbbb.cccc.
Also reconfigure the same MAC address on the VLT peer switch.
Use this command to minimize the time required for the VLT system to synchronize the default MAC address of the VLT domain on
both peer switches when one peer switch reboots.
7. When you create a VLT domain on a switch, Dell EMC Networking OS automatically assigns a unique unit ID (0 or 1) to each peer
switch. To explicitly configure the default values on each peer switch, use the following command.
VLT DOMAIN CONFIGURATION mode
unit-id {0 | 1}
The unit IDs are used for internal system operations.
Configure a different unit ID (0 or 1) on each peer switch.
Use this command to minimize the time required for the VLT system to determine the unit ID assigned to each peer switch when one
peer switch reboots.
8. Configure enhanced VLT. Configure the port channel to be used for the VLT interconnect on a VLT switch and enter interface
configuration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number configured with the peer-link port-channel command in the Enabling VLT and Creating
a VLT Domain.
9. Place the interface in Layer 2 mode.
INTERFACE PORT-CHANNEL mode
switchport
10. Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.
INTERFACE PORT-CHANNEL mode
vlt-peer-lag port-channel id-number
11. Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
12. Add links to the eVLT port. Configure a range of interfaces to bulk configure.
CONFIGURATION mode
interface range {port-channel id}
13. Enable LACP on the LAN port.
INTERFACE mode
port-channel-protocol lacp
14. Configure the LACP port channel mode.
INTERFACE mode
port-channel number mode [active]
15. Ensure that the interface is active.
MANAGEMENT INTERFACE mode
no shutdown
16. Enable peer routing.
VLT DOMAIN CONFIGURATION mode
Virtual Link Trunking (VLT)
861