Administrator Guide

Port-channel 1, IPv4 VRID: 1, Version: 2, Net: 10.1.1.1
VRF: 2 vrf2
State: Master, Priority: 100, Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 419, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.100
Authentication: (none)
VRRP for IPv6 Configuration
This section shows VRRP IPv6 topology with CLI configurations.
Consider an example VRRP for IPv6 configuration in which the IPv6 VRRP group consists of two routers.
Figure 150. VRRP for IPv6 Topology
NOTE:
This example does not contain comprehensive directions and is intended to provide guidance for only a typical
VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to
support your own IP addresses, interfaces, names, and so on.
Virtual Router Redundancy Protocol (VRRP) 945