Reference Guide
timers lsa arrival
Congures the LSA acceptance intervals.
Syntax
timers lsa arrival arrival-time
Parameters arrival-time — Set the interval between receiving the LSA in milliseconds (0 to 600,000).
Default 1000 milliseconds
Command Mode ROUTER-OSPF
Usage Information Setting the LSA arrival time between receiving the LSA repeatedly ensures that the system gets enough time to
accept the LSA. The no version of this command resets the value to the default.
Example
OS10(conf-router-ospf-1)# timers lsa arrival 2000
Supported Releases 10.2.0E or later
timers throttle lsa all
Congures the LSA transmit intervals.
Syntax
timers lsa all [start-innterval | hold-interval | max-interval]
Parameters
• start-interval — Sets the minimum interval between initial sending and re-sending the same LSA in
milliseconds (0 to 600,000).
• hold-interval — Sets the next interval to send the same LSA in milliseconds. This is the time between
sending the same LSA after the start-interval has been attempted (1 to 600,000).
•
max-interval — Sets the maximum amount of time the system waits before sending the LSA in
milliseconds (1 to 600,000).
.
Default
• start-interval — 0 milliseconds
• hold-interval — 5000 milliseconds
• max-interval — 5000 milliseconds
Command Mode ROUTER-OSPF
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-router-ospf-1)# timers throttle lsa all 100 300 1000
Supported Releases 10.2.0E or later
OSPFv3 Commands
300
Layer 3