Reference Guide
ipv6 ospf hello-interval
Sets the time interval between hello packets sent on an interface.
Syntax
ipv6 ospf hello-interval seconds
Parameters seconds — Enter the hello-interval value in seconds (1 to 65535).
Default 10 seconds
Command Mode INTERFACE
Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the
this command resets the value to the default.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30
Supported Releases 10.3.0E or later
ipv6 ospf network
Sets the network type for the interface.
Syntax
ipv6 ospf network {point-to-point | broadcast}
Parameters
• point-to-point — Sets the interface as part of a point-to-point network.
• broadcast — Sets the interface as part of a broadcast network.
Default Broadcast
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ipv6 ospf network broadcast
Supported Releases 10.3.0E or later
ipv6 ospf passive
Congures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface.
Syntax
ipv6 ospf passive
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information You must congure the interface before setting the interface to passive mode. The no version of the this
command disables the Passive interface conguration.
Example
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf passive
304 Layer 3