Reference Guide

Supported Releases 10.3.0E or later
ipv6 ospf priority
Sets the priority of the interface to determine the designated router for the OSPFv3 network.
Syntax
ipv6 ospf priority number
Parameters number — Enter a router priority number (0 to 255).
Default 1
Command Mode INTERFACE
Usage Information When two routers attached to a network attempt to become the designated router, the one with the higher router
priority takes precedence. The no version of this command resets the value to the default.
Example
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4
Supported Releases 10.3.0E or later
redistribute
Redistributes information from another routing protocol or routing instance to the OSPFv3 process.
Syntax
redistribute {bgp as-number route-map route-map name | connected | static}
Parameters
• as-number — Enter an autonomous number to redistribute BGP routing information throughout the OSPFv3
instance (1 to 4294967295).
• route-map name — Enter the name of a congured route-map.
• connected — Enter the information from connected (active) routes on interfaces to redistribute.
• static — Enter the information from static routes on interfaces redistribute.
Defaults Not congured
Command Mode ROUTER-OSPF and ROUTER-OSPFv3
Usage Information When an OSPFv3 redistributes, the process is not completely removed from the BGP conguration. The no
version of this command disables the redistribute conguration.
Example
OS10(config)# router ospfv3 10
OS10(conf-router-ospf-10)# redistribute bgp 4 route-map dell1
Example
(Connected)
OS10(conf-router-ospf-10)# redistribute connected route-map dell2
Supported Releases 10.3.0E or later
router-id
Congures a xed router ID for the OSPFv3 process.
Syntax
router-id ip-address
Parameters ip-address — Enter the IP address of the router as the router ID.
Layer 3 305