Reference Guide

Default Disabled
Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL
Usage Information The no version of this command deletes the ACL description.
Example
OS10(conf-ipv4-acl)# description ipacltest
Supported Releases 10.2.0E or later
ip access-group
Assigns an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of an IPv4 access list (up to 140 characters).
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command deletes an IP ACL conguration.
Example
OS10(conf-if-eth1/1/8)# ip access-group testgroup in
Supported Releases 10.2.0E or later
ip access-list
Creates an IP access list (IP ACL) to lter based on an IP address.
Syntax
ip access-list access-list-name
Parameters access-list-name — Enter the name of an IPv4 access list (up to 140 characters).
Default Not congured
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# ip access-list acl1
Supported Releases 10.2.0E or later
ip as-path deny
Denes a BGP access list.
Syntax
ip as-path access-list name deny ASNumber
396 Access Control Lists