Reference Guide

Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 deny udp any any capture session 1 count
Supported Releases 10.2.0E or later
seq permit
Assigns a sequence number to permit packets while creating the lter.
Syntax
seq sequence-number permit [protocol-number A.B.C.D | A.B.C.D/x | any | host
ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count
[byte] | dscp value| fragment]]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number (0 to 4294967295).
• protocol-number — (Optional) Enter the protocol number (0 to 255).
• A.B.C.D — Enter the IP address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Set all routes which are subject to the lter:
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values (0 to 63).
• fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IP address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# seq 10 permit ip any any capture session 1 count
Supported Releases 10.2.0E or later
seq permit (IPv6)
Assigns a sequence number to permit IPv6 packets, while creating a lter.
Syntax
seq sequence-number permit protocol-number [A::B | A::B/x | any | host ipv6-
address] [A::B | A:B/x | any | host ipv6-address] [capture | count [byte] |
dscp value | fragment]
Access Control Lists 421