Reference Guide
Usage Information OS10 cannot count both packets and bytes — when you congure the count byte options, only bytes
increment. Use the no version of this command to remove the lter, or use the no seq sequence-number
command if you know the lter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan
2
Supported Releases 10.2.0E or later
seq permit icmp
Assigns a sequence number to allow ICMP messages while creating the lter
Syntax
seq sequence-number permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count [byte] | dscp
value| fragment]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number (0 to 4294967295).
• A.B.C.D — Enter the IP address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Set all routes are which subject to the lter:
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values (0 to 63).
• fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IP address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Example
OS10(config)# ip access-list egress
OS10(conf-ipv4-acl)# seq 5 permit icmp any any capture session 1 count
Supported Releases 10.2.0E or later
seq permit icmp (IPv6)
Assigns a sequence number to allow ICMP messages while creating the lter.
Syntax
seq sequence-number permit icmp [A::B | A::B/x | any | host ipv6-address] [A::B
| A:B/x | any | host ipv6-address] [capture | count [byte] | dscp value |
fragment]
Access Control Lists 423