Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

421

422

423

424

425

426

427

428

429

430

• fragment — (Optional) Use ACLs to control packet fragments.

• eq — (Optional) Deny packets which are equal to.

• ack — (Optional) Set the bit as acknowledgement.

• fin — (Optional) Set the bit as nish (no more data from sender).

• psh — (Optional) Set the bit as push.

• rst — (Optional) Set the bit as reset.

• syn — (Optional) Set the bit as synchronize.

• urg — (Optional) Set the bit set as urgent.

• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.

Default Not congured

Command Mode IPV6-ACL

Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.

Use the no version of this command to remove the lter, or use the no seq sequence-number command if

you know the lter’s sequence number.

Example

OS10(config)# ipv6 access-list egress

OS10(conf-ipv6-acl)# seq 5 permit tcp any any capture session 1 count

Supported Releases 10.2.0E or later

seq permit udp

Assigns a sequence number to allow UDP packets while creating the lter.

Syntax

seq 0–4294967295 permit udp [A.B.C.D | A.B.C.D/x | any | host ip-address [eq]]

[[A.B.C.D | A.B.C.D/x | any | host ip-address [eq] ] [ack | fin | psh | rst |

syn | urg] [capture |count [byte] | dscp value | fragment]

Parameters

• A.B.C.D — Enter the IP address in dotted decimal format.

• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.

• any — (Optional) Set all routes which are subject to the lter:

• capture — (Optional) Capture packets the lter processes.

• count — (Optional) Count packets the lter processes.

• byte — (Optional) Count bytes the lter processes.

• dscp value — (Optional) Deny a packet based on the DSCP values (0 to 63).