Reference Guide
Usage Information Use the iscsi aging time command to congure the aging timeout in iSCSI monitoring sessions, and use the
iscsi target port command to congure the TCP ports that listen for connected storage devices in iSCSI
monitoring sessions. The
no version of this command disables iSCSI session monitoring.
Example
OS10(config)# iscsi session-monitoring enable
Supported Releases 10.3.0E or later
iscsi target port
Congures the TCP ports used to monitor iSCSI sessions with target storage devices.
Syntax
iscsi target port tcp-port1 [tcp-port2, ..., tcp-port16] [ip-address ip-
address]
Parameters
• tcp-port — Enter one or more TCP port numbers (0 to 65535). Separate TCP port numbers with a comma.
• ip-address ip-address — (Optional) Enter the IP address in A.B.C.D format of a storage array whose
iSCSI trac is monitored on the TCP port.
Default 3260,860
Command Mode CONFIGURATION
Usage Information You can congure up to 16 TCP ports to monitor iSCSI trac from target storage devices. The no version of this
command including the IP address removes a TCP port from iSCSI monitoring.
Example
OS10(config)# iscsi target port 26,40
Supported Releases 10.3.0E or later
lldp tlv-select dcbxp-appln iscsi
Enables a port to advertise iSCSI application TLVs to DCBX peers.
Syntax
lldp tlv-select dcbxp-appln iscsi
Parameter None
Default iSCSI application TLVs are advertised to DCBX peers.
Command Mode INTERFACE
Usage Information DCB devices use DCBX to exchange iSCSI conguration information with peers and self-congure. iSCSI
parameters are exchanged in time, length, and value (TLV) messages. DCBX requires LLDP enabled to advertise
iSCSI application TLVs. iSCSI application TLVs advertise the PFC dot1p priority-bitmap congured with the iscsi
priority-bits command to DCBX peers. If you do not congure an iSCSI dot1p-bitmap value, iSCSI
application TLVs advertise dot1p 4 by default only if you congure dot1p 4 as a PFC priority with the
pfc-cos
command. The no version of this command disables iSCSI TLV transmission.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp-appln iscsi
Supported Releases 10.3.0E or later
536 Converged data center services