Reference Guide

interface ethernet
Congures a physical Ethernet interface.
Syntax
interface ethernet node/slot/port:subport
Parameters node/slot/port:subport — Enter the Ethernet interface information.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface ethernet 1/1/10:1
OS10(conf-if-eth1/1/10:1)#
Supported Releases 10.2.0E or later
interface loopback
Congures a loopback interface.
Syntax
interface loopback id
Parameters id — Enter the loopback interface ID number (0 to 16383).
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the loopback interface.
Example
OS10(config)# interface loopback 100
OS10(conf-if-lo-100)#
Supported Releases 10.2.0E or later
interface mgmt
Congures the Management port.
Syntax
interface mgmt node/slot/port
Parameters node/slot/port — Enter the physical port interface information for the Management interface.
Default Enabled
Command Mode CONFIGURATION
Usage Information You cannot delete a Management port. To assign an IP address to the Management port, use the ip address
command.
Example
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)#
Supported Releases 10.2.0E or later
76 Interfaces