Users Guide

Default Not configured
Command Mode
CONFIGURATION
CONTROL-PLANE
Usage
Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are
only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports.
The no version of this command resets the value to the default.
Example
OS10(config)# mac access-group maclist in
OS10(conf-mac-acl)#
Example
(Control-plane
ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# mac access-group maclist in
Supported
Releases
10.2.0E or later; 10.4.1 or later (control-plane ACL)
mac access-list
Creates a MAC access list to filter based on a MAC address.
Syntax
mac access-list access-list-name
Parameters access-list-name Enter the name of a MAC access list. A maximum of 140 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# mac access-list maclist
Supported
Releases
10.2.0E or later
permit
Configures a filter to allow packets with a specific IPv4 address.
Syntax
permit [protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any
| host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture |
count | dscp value | fragment | log]
Parameters
protocol-number (Optional) Enter the protocol number identified in the IP header, from 0 to
255.
icmp (Optional) Enter the ICMP address to permit.
ip (Optional) Enter the IPv4 address to permit.
tcp (Optional) Enter the TCP address to permit.
udp (Optional) Enter the UDP address to permit.
A.B.C.D Enter the IPv4 address in dotted decimal format.
A.B.C.D/x Enter the number of bits that must match the dotted decimal address.
any (Optional) Enter the keyword any to specify any source or destination IP address.
host ip-address (Optional) Enter the IPv4 address to use a host address only.
capture (Optional) Capture packets the filter processes.
count (Optional) Count packets the filter processes.
Access Control Lists 1493