Users Guide

Supported
Releases
10.3.0E or later
queue bandwidth
Configures a bandwidth for a given queue on interface.
Syntax
queue queue-number bandwidth bandwidth-percentage
Parameters
● queue-number — Enter the queue number.
● bandwidth-percentage — Enter the percentage of bandwidth.
Default Not configured
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
The no version of this command removes the bandwidth from the queue.
Example None
Supported
Releases
10.4.0E(R1) or later
queue qos-group
Configures a dot1p traffic class to a queue.
Syntax
queue number [qos-group dot1p-values]
Parameters
● queue number — Enter the traffic single value queue ID, from 0 to 7.
● qos-group dot1p-values — (Optional) Enter either single, comma-delimited, or a hyphenated
range of dot1p values, from 0 to 7.
Default 0
Command Mode TRUST-MAP
Usage
Information
If the trust map does not define traffic class values to a queue, those flows map to the default queue 0. If
some of the traffic class values are already mapped to an existing queue, you see an error. The no version
of this command returns the value to the default.
Example
OS10(conf-tmap-tc-queue-qos)# queue 2 qos-group 5
Supported
Releases
10.3.0E or later
queue qos-group (Z9332F-ON)
Configure mapping for different traffic class types to different queues.
Syntax
queue number qos-group traffic-class-numbertype {unicast | multicast}
Parameters
● queue number — Enter the traffic single value queue ID, from 0 to 7. Multicast Queue ranges from
0 to 2.
● qos-group traffic-class-number — Enter the traffic class number, either single, comma-
delimited, or hyphenated-range
● typeunicast | multicast — Select either a unicast or multicast queue type
Default NA
Command Mode CONFIGURATION (config-qos-map)
1592 Quality of service