Users Guide

logging console
Disables, enables, or configures the minimum severity level for logging to the console.
Syntax
logging console {disable | enable | severity}
Parameters severity—Set the minimum logging severity level:
● log-emerg—Set to unusable.
● log-alert—Set to immediate action is needed.
● log-crit—Set to critical conditions.
● log-err—Set to error conditions.
● log-warning—Set to warning conditions.
● log-notice—Set to normal but significant conditions, the default.
● log-info—Set to informational messages.
● log-debug—Set to debug messages.
Default Log-notice
Command Mode CONFIGURATION
Usage
Information
To set the severity to the default level, use the no logging console severity command. The
default severity level is log-notice.
NOTE: The system rate-limits syslog messages to a maximum of 10 per second on the console.
Example
OS10(config)# logging console disable
Example (Enable)
OS10(config)# logging console enable
Example
(Severity)
OS10(config)# logging console severity log-warning
Supported
Releases
10.2.0E or later
logging enable
Enables system logging.
Syntax
logging enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables all logging.
Example
OS10(config)# logging enable
Supported
Releases
10.2.0E or later
logging log-file
Disables, enables, or sets the minimum severity level for logging to the log file.
Syntax
logging log-file {disable | enable | severity}
Troubleshoot Dell EMC SmartFabric OS10 1817