Users Guide

● excluded — (Optional) Exclude the MIB family from the view.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The oid-tree value specifies the OID in the MIB tree hierarchy at which a view starts. Enter included
or excluded to include or exclude the remaining part of the MIB sub-tree contents in the view.
The no version of the command removes an SNMPv3 view.
Example
OS10(config)# snmp-server view readview 1.3.6.5 excluded
Supported
Releases
10.4.2.0 or later
snmp-server vrf
Configures an SNMP agent to receive SNMP traps for the management VRF instance.
Syntax
snmp-server vrf management
Parameters None
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the SNMP agent from receiving the SNMP traps.
Example
OS10(config)# snmp-server vrf management
Supported
Releases
10.4.1.0 or later
snmp-server source interface
Specifies an interface and its IP address as the source address for SNMP packets that are sent to a remote server.
Syntax
snmp-server source-interface {loopback number| mgmt 1/1/1}
Parameters
● loopback number — Enter a loopback interface from 0 to 16383.
● mgmt 1/1/1 — Enter the management interface.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
● By default, no source interface is configured. If you do not specify a source interface, OS10 selects
the source IP address as the IP address of the interface from which a packet is sent to the remote
server.
● The no version of this command removes the configured source interface.
Example
OS10(config)# snmp-server source-interface loopback 1
Supported
Releases
10.5.2.0 or later
182 System management