Users Guide

OS10(conf-if-eth1/1/9)# ip address 10.10.1.92/24
OS10(conf-if-eth1/1/9)# no shutdown
View L3 configuration error
OS10(config)# interface ethernet 1/1/14
OS10(conf-if-eth1/1/14)# ip address 10.1.1.2/24
% Error: Interface ethernet1/1/14, IP address cannot exist with L2 modes.
Fibre Channel interfaces
OS10 unified port groups support FC interfaces. A unified port group operates in Fibre Channel or Ethernet mode. To activate
FC interfaces, configure a port group to operate in Fibre Channel mode and specify the port speed. By default, FC interfaces are
disabled.
S4148U-ON
On a S4148U-ON switch, FC interfaces are available in all port groups. The activated FC interfaces depend on the currently
configured port profile. For more information, see S4148U-ON port profiles.
Figure 3. S4148U-ON unified port groups
1. Configure a unified port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the
switch.
port-group node/slot/port-group
2. Activate the unified port group for FC operation in PORT-GROUP mode. The available FC modes depend on the switch.
mode fc {32g-4x | 32g-2x | 32g-1x | 16g-4x | 16g-2x | 8g-4x}
● 8g-4x — Split a unified port group into four 8 GFC interfaces.
● 16g-2x — Split a unified port group into two 16 GFC interfaces.
● 16g-4x — Split a unified port group into four 16 GFC interfaces.
● 32g-1x — Split a unified port group into one 32 GFC interface. A 1x-32G interface has a rate limit of 28G.
● 32g-2x — Split a unified port group into two 32 GFC interfaces.
● 32g-4x — Split a unified port group into four 32 GFC interfaces. Each 4x-32GE breakout interface has a rate limit of
25G.
3. Return to CONFIGURATION mode.
exit
4. Enter FC Interface mode to enable data transmission. Enter a single interface, a hyphen-separated range, or multiple
interfaces separated by commas.
interface fibrechannel node/slot/port[:subport]
5. (Optional) Reconfigure the interface speed in INTERFACE mode.
speed {8 | 16 | 32 | auto}
364
Interfaces