Users Guide
show interface ethernet eee
Displays the EEE status for a specified interface.
Syntax
show interface ethernet node/slot/port[:subport] eee
Parameters node/slot/port[:subport]—Enter the interface information.
Default Not configured
Command Mode EXEC
Example
OS10# show interface ethernet 1/1/48 eee
Port EEE Status Speed Duplex
---------------------------------------------
Eth 1/1/48 on up 1000M
Supported
Releases
10.3.0E or later
show interface ethernet eee statistics
Displays EEE statistics for a specified interface.
Syntax
show interface ethernet node/slot/port[:subport] eee statistics
Parameters node/slot/port[:subport]—Enter the interface information.
Default Not configured
Command Mode EXEC
Example
OS10# show interface ethernet 1/1/48 eee statistics
Eth 1/1/48
EEE : on
TxIdleTime(us) : 2560
TxWakeTime(us) : 5
Last Clearing : 18:45:53
TxEventCount : 0
TxDuration(us) : 0
RxEventCount : 0
RxDuration(us) : 0
Supported
Releases
10.3.0E or later
View interface configuration
To view basic interface information, use the show interface, show running-configuration, and show interface
status commands. Stop scrolling output from a show command by entering CTRL+C. Display information about a physical or
virtual interface in EXEC mode, including up/down status, MAC and IP addresses, and input/output traffic counters.
show interface [type]
● phy-eth node/slot/port[:subport] — Display information about physical media connected to the interface.
● status — Display interface status.
● ethernet node/slot/port[:subport] — Display Ethernet interface information.
● loopback id — Display Loopback interface information, from 0 to 16383.
● mgmt node/slot/port — Display Management interface information.
● port-channel id-number — Display port-channel interface information, from 1 to 128.
● vlan vlan-id — Display the VLAN interface information, from 1 to 4093.
Interfaces
385