Users Guide

lldp vlan-name-tlv allowed vlan
Specifies a single or multiple VLANs' names to transmit in LLDPDUs.
Syntax
lldp vlan-name-tlv allowed vlan vlan-id
Parameters vlan-id—Specify a single VLAN or multiple VLANs.
Default Disabled
Command Mode INTERFACE
Usage
Information
This command specifies VLANs' names to transmit in LLDPDUs along with the configured default VLAN. If
you do not use this command, the interface sends the name of the default VLAN if a name is configured.
If you use this command to transmit multiple VLAN names, any VLAN configured without a name is
excluded.
An interface can transmit a maximum of eight VLAN names. If you specify 10 VLANs and if the default
VLAN configured has a name, the interface transmits LLDPDUs with VLAN names of the default VLAN
and the first seven VLANs that have a name configured. If the default VLAN does not have a name
configured, the interface transmits the VLAN names of the first eight VLANs that have a name
configured and excludes the default VLAN.
This command is accessible to users with sysadmin, secadmin, and netadmin roles.
Example
OS10(conf-if-eth1/1/1)# lldp vlan-name-tlv allowed vlan vlan2
OS10(conf-if-eth1/1/1)# lldp vlan-name-tlv allowed vlan
2-10,12,14-16,20,24
Supported
Releases
10.5.0 or later
show lldp interface
Displays the LLDP information that is advertised from a specific interface.
Syntax
show lldp interface ethernet node/slot/port[:subport] [local—device | med]
Parameters
● ethernet node/slot/port[:subport] — Enter the Ethernet interface information.
● local-device — Enter the interface to view the local-device information.
● med — Enter the interface to view the MED information.
Default None
Command Mode EXEC
Usage
Information
Use the med parameter to view MED information for a specific interface. Use the local-device
parameter to view inventory details.
Example
OS10# show lldp interface ethernet 1/1/5
ethernet1/1/5
Tx State : Enabled
Rx State : Enabled
Tx SEM State : initialize
Rx SEM State : wait-port-operational
Notification Status : Disabled
Notification Type : mis-configuration
DestinationMacAddr : 01:80:c2:00:00:0e
Example (Local
Device)
OS10# show lldp interface ethernet 1/1/1 local-device
Device ID: 90:b1:1c:f4:a6:25
Port ID: ethernet1/1/2:1
Layer 2 585