Users Guide
NOTE:
● For a regular switch port in Trunk mode, you must tag all VLANs of the PVLAN domain.
● If you enable local proxy arp in the primary VLAN, both the host and the primary VLAN (as the local proxy) send
an ARP reply.
1. Enter Configuration mode.
OS10# configure terminal
2. Enter Interface Configuration mode.
OS10(config)# interface ethernet 1/1/4
3. Configure the Switchport mode as trunk for the port to carry more than single VLAN traffic.
OS10(conf-if-eth1/1/4)# switchport mode trunk
4. Associate the port to be a trunk member of the primary and secondary VLANs.
OS10(conf-if-eth1/1/4)# switchport trunk allowed vlan 10
OS10(conf-if-eth1/1/4)# switchport trunk allowed vlan 20
OS10(conf-if-eth1/1/4)# switchport trunk allowed vlan 30
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,
@ – Attached to Virtual Network, P - Primary, C - Community, I - Isolated
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 Active A Eth1/1/6-1/1/32
P 10 Active A Eth1/1/1
T Eth1/1/4-1/1/5
I 20 Active T Eth1/1/2
T Eth1/1/4
C 30 Active A Eth1/1/3
T Eth1/1/4
Configure PVLAN ports in a regular VLAN
This section describes how to configure PVLAN ports in regular VLANs.
You can configure a PVLAN port as a tagged and untagged member of regular VLANs.
Configure a PVLAN port as tagged and untagged member of regular VLANs
You can configure a PVLAN port as tagged and untagged member of regular VLANs.
Configure the port to be a trunk member of a secondary VLAN and a regular VLAN.
1. Enter Configuration mode.
OS10# configure terminal
2. Enter Interface Configuration mode.
OS10(config)# interface ethernet 1/1/2
3. Configure Switchport mode as a PVLAN secondary port.
OS10(conf-if-eth1/1/2)# private-vlan mode secondary-port
4. Configure Switchport mode as trunk to carry more than single VLAN traffic.
OS10(conf-if-eth1/1/2)# switchport mode trunk
Layer 2
667