Users Guide
Net Link States (Area 0.0.0.0)
ADV Router Age Seq# Link ID Rtr count
----------------------------------------------------------
2.2.2.2 1045 0x80000001 5 2
Inter Area Router States (Area 0.0.0.0)
ADV Router Age Seq# Link ID Dest RtrID
---------------------------------------------------------------
1.1.1.1 1605 0x80000027 1 3.3.3.3
Link (Type-8) Link States (Area 0.0.0.0)
ADV Router Age Seq# Link ID Interface
--------------------------------------------------------------------
1.1.1.1 1615 0x80000125 5 ethernet1/1/1
2.2.2.2 1369 0x8000011B 5 ethernet1/1/1
10.0.0.2 1044 0x80000001 5 ethernet1/1/1
Type-5 AS External Link States
ADV Router Age Seq# Prefix
--------------------------------------------------------------------------
3.3.3.3 3116 0x80000126 400::/64
3.3.3.3 3116 0x80000124 34::/64
Supported
Releases
10.3.0E or later
show ipv6 ospf interface
Displays the configured OSPFv3 interfaces. You must enable OSPFv3 to display the output.
Syntax
show ipv6 ospf interface interface [vrf vrf-name]
Parameters
● interface — (Optional) Enter the interface information:
○ ethernet — Physical interface, from 1 to 48.
○ port-channel — Port-channel interface, from 1 to 128.
○ vlan — VLAN interface, from 1 to 4093.
● vrf vrf-name — (Optional) Enter the keyword vrf followed by the name of the VRF to display
the configured OSPFv3 enabled interfaces in that VRF.
Default Not configured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role
Active
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported
Releases
10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf [vrf vrf-name] neighbor
Parameters
● vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to display a list of
OSPFv3 neighbors in that VRF.
Layer 3 983