Reference Guide

Example
OS10# clear ip ospf 10 statistics
Supported
Releases
10.4.0E(R1) or later
default-information originate
Generates and distributes a default external route information to the OSPF routing domain.
Syntax
default-information originate [always]
Parameters always — (Optional) Always advertise the default route.
Defaults Disabled
Command Mode ROUTER-OSPF
Usage
Information
The no version of this command disables the distribution of default route.
Example
OS10(config)# router ospf 10
OS10(config-router-ospf-10)# default-information originate always
Supported
Releases
10.3.0E or later
default-metric
Assigns a metric value to redistributed routes for the OSPF process.
Syntax
default-metric number
Parameters number — Enter a default-metric value (1 to 16777214).
Default Not configured
Command Mode ROUTER-OSPF
Usage
Information
The no version of this command disables the default-metric configuration.
Example
OS10(conf-router-ospf-10)# default-metric 2000
Supported
Releases
10.2.0E or later
fast-converge
Sets the minimum LSA origination and arrival times to zero (0) allowing more rapid route computation so that convergence
takes less time.
Syntax
fast-converge convergence-level
Parameters convergence-level — Enter a desired convergence level value (1 to 4).
Default Not configured
Command Mode ROUTER-OSPF
Usage
Information
Convergence level 1 (optimal) meets most convergence requirements. Only select higher convergence
levels following consultation with Dell Technical Support. The no version of this command disables the
fast-convergence configuration.
Layer 3 395