Reference Guide

Example
OS10# show sessions
Current session's operation mode: Non-transaction
Session-ID User In-rpcs In-bad-rpcs Out-rpc-err Out-notify Login-time Lock
-----------------------------------------------------------------------------------------
3 snmp_user 114 0 0 0 2017-07-10T23:58:39Z
4 snmp_user 57 0 0 0 2017-07-10T23:58:40Z
6 admin 17 0 0 4 2017-07-12T03:55:18Z
*7 admin 10 0 0 0 2017-07-12T04:42:55Z
OS10#
Supported
Releases
10.3.1E or later
Telnet server
To allow Telnet TCP/IP connections to an OS10 switch, enable the Telnet server. The OS10 Telnet server uses the Debian
telnetd package. By default, the Telnet server is disabled.
When the Telnet server is enabled, connect to the switch using the IP address configured on the management or any front-
panel port. The Telnet server configuration is persistent and is maintained after you reload the switch. To verify the Telnet
server configuration, enter the show running-configuration command.
Enable Telnet server
OS10(config)# ip telnet server enable
Disable Telnet server
OS10(config)# no ip telnet server enable
By default, the Telnet server is disabled on the default VRF. To configure the Telnet server to be reachable on the management
VRF, use the ip telnet server vrf management command.
Configure Telnet server on management VRF
OS10(config)# ip telnet server vrf management
Telnet commands
ip telnet server enable
Enables Telnet TCP/IP connections to an OS10 switch.
Syntax
ip telnet server enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage
Information
By default, the Telnet server is disabled. When you enable the Telnet server, use the IP address
configured on the management or any front-panel port to connect to an OS10 switch. After you reload
the switch, the Telnet server configuration is maintained. To verify the Telnet server configuration, enter
the show running-configuration command.
Example
OS10(config)# ip telnet server enable
Example
(disable)
OS10(config)# no ip telnet server enable
490 System management