Administrator Guide

Denying and Permitting Access to a Terminal Line
Dell Networking recommends applying only standard access control lists (ACLs) to deny and permit access to VTY lines.
• Layer 3 ACLs deny all trac that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny trac.
• You cannot use the show ip accounting access-list command to display the contents of an ACL that is applied only to a
VTY line.
• When you use the access-class access-list-name command without specifying the ipv4 or ipv6 attribute, both IPv4 as
well as IPv6 rules that are dened in that ACL are applied to the terminal. This method is a generic way of conguring access
restrictions.
• To be able to lter access exclusively using either IPv4 or IPv6 rules, use either the ipv4 or ipv6 attribute along with the access-
class access-list-name command. Depending on the attribute that you specify (ipv4 or ipv6), the ACL processes either
IPv4 or IPv6 rules, but not both. Using this conguration, you can set up two dierent types of access classes with each class
processing either IPv4 or IPv6 rules separately.
To apply an IP ACL to a line, Use the following command.
• Apply an ACL to a VTY line.
LINE mode
access-class access-list-name [ipv4 | ipv6]
NOTE: If you already have congured generic IP ACL on a terminal line, then you cannot further apply IPv4 or IPv6
specic ltering on top of this conguration. Similarly, if you have congured either IPv4 or IPv6 specic ltering on a
terminal line, you cannot apply generic IP ACL on top of this conguration. Before applying any of these congurations,
you must rst undo the existing conguration using the no access-class access-list-name [ipv4 | ipv6]
command.
Example of an ACL that Permits Terminal Access
Example Conguration
To view the conguration, use the show config command in LINE mode.
Dell(config-std-nacl)#show config
!
ip access-list standard myvtyacl
seq 5 permit host 10.11.0.1
Dell(config-std-nacl)#line vty 0
Dell(config-line-vty)#show config
line vty 0
access-class myvtyacl
Dell(conf-ipv6-acl)#do show run acl
!
ip access-list extended testdeny
seq 10 deny ip 30.1.1.0/24 any
seq 15 permit ip any any
!
ip access-list extended testpermit
seq 15 permit ip any any
!
ipv6 access-list testv6deny
seq 10 deny ipv6 3001::/64 any
seq 15 permit ipv6 any any
!
Dell(conf)#
Dell(conf)#line vty 0 0
Dell(config-line-vty)#access-class testv6deny ipv6
Dell(config-line-vty)#access-class testvpermit ipv4
Dell(config-line-vty)#show c
line vty 0
Management
79